#310 IBIS 3C FLEXO FOLDER GLUER

updated 7/16/15

General

• Blank width:
• Min:     11 ⅞”
• Max:    47 ¼” Can go up to 63” with skid feed
• Blank length:
• Min:     31”
• Max:    119 ¾”

• Minimum panel sizes: 
• If joint is on the large panel:
• 7 ⅞” length
• 7” width (exception: 4 ” width if length + width >= than 14 ⁷/₈”)
• 2 ⅞” depth 
• If joint is on the small panel:
• 7 ⅞” length
• 7 ⅞ ” width
• 2 ⅞” depth

• 1 ½” extended glue flap max

• Capable of running outside glue flap

• Maximum Depth + Slot must not exceed 50”

• Die cut section:
• 50” cylinder

• Printing:
• 3 color
• 50” cylinder
• 250 line anilox rolls
• Max 55 line
• A minimum font size would be no less than 6 point which is approximately a ¹/₁₆”. This is usually dictated by the substrate. As always, **ALL** print is subject to approval.

• Can also run pads, printed sheets, trays, and 2 piece boxes that are routed to a down stacker and converted at a secondary operation elsewhere